Honda Odyssey Owners Manual: High Beam Headlight

Driver’s side

1. Remove the clips using a flat-tip screwdriver, then remove the upper part of the air intake duct.

Passenger’s side

1. Remove the clips using a flat-tip screwdriver, then remove the engine coolant reservoir out of its stay.

Remove the power steering reservoir from the stay bracket.

Holding clip

Insert a flat-tip screwdriver, lift and remove the central pin to remove the clip.

Insert the clip with the central pin raised, and push until it is flat.

2. Remove the coupler.
►  It can be removed by pushing the tab.
3. Rotate the old bulb to the left to remove.
4. Insert a new bulb into the headlight assembly and turn it to the right.
5. Insert the coupler into the connector of the bulb.

    Headlight Bulbs

    Low Beam Headlights

    See More:

    Honda Odyssey Service Manual > Data and Communication Network: Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (USA model)
    Special Tools Required Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0 USA models NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. Removal Do the battery terminal disconnection procedure. Remo ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2021 Copyright www.hodyssey.net
    0.0112