Honda Odyssey Owners Manual: Jump Starting

WARNING
A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby.

Keep all sparks, open flames, and smoking materials away from the battery.

Securely attach the jumper cables clips so that they do not come off when the engine vibrates. Also be careful not to tangle the jumper cables or allow the cable ends to touch each other while attaching or detaching the jumper cables.

Battery performance degrades in cold conditions and may prevent the engine from starting.

■Jump Starting Procedure

Turn off the power to electric devices, such as audio and lights. Turn off the engine, then open the hood.

1. Connect the first jumper cable to your vehicle's battery terminal.
2. Connect the other end of the first jumper cable to the assisting vehicle's terminal.
►  Use a 12-volt booster battery only.
3. Connect the second jumper cable to the assisting vehicle's terminal.

4. Connect the other end of the second jumper cable to the grounding point as shown.
Do not connect this jumper cable to any other part.
5. If your vehicle is connected to another vehicle, start the assisting vehicle's engine and increase its rpm slightly.
6. Attempt to start your vehicle's engine. If it turns over slowly, check that the jumper cables have good metal-to-metal contact.

■What to Do After the Engine Starts

Once your vehicle's engine has started, remove the jumper cables in the following order.

1. Disconnect the jumper cable from your vehicle's ground.
2. Disconnect the other end of the jumper cable from the assisting vehicle's battery terminal.
3. Disconnect the jumper cable from your vehicle's battery terminal.
4. Disconnect the other end of the jumper cable from the assisting vehicle's battery terminal.

Have your vehicle inspected by a nearby service station or a dealer.

    Engine Does Not Start

    Shift Lever Does Not Move

    See More:

    Honda Odyssey Service Manual > Window Control: Power Window Master Switch Replacement
    Carefully remove the power window master switch panel (A). DCAB Disconnect the 37P connector (B) from the power window master switch, and the 13P connector (C) from the power mirror switch (D). Remove the four screws and the power window master switch (A). A Install the switch in the reverse order ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2020 Copyright www.hodyssey.net
    0.0211