Honda Odyssey Service Manual: Multi-Information Switch Test/Replacement

Honda Odyssey Service Manual / Accessories / Multi-Information Switch Test/Replacement

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

  1. Remove the driver's airbag assembly.

  1. Remove the three screws (A), then remove the steering wheel trim (B), and disconnect connectors (C) from each switches.

  2. 1 2 3 4 5 AACBDFEE
  3. Remove the cover (D).

  4. Remove the switch mounting screws (E), then remove the multi-information switch (F) from the steering wheel trim.

  5. Measure the resistance between terminals No. 1 and No. 5 in each position according to the table.

    Position

    Resistance

    ^

    About 33 ?

    SEL/RESET

    About 1043 ?

    Ў

    About 363 ?

  6. If the switch is OK, but there is a problem with the switch function, check the cable reel subharness and cable reel.

    Accessories

    Towing

    See More:

    Honda Odyssey Service Manual > Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation: Removal
    Remove the alternator. Clamp the alternator firmly in a vise. Remove the over-run alternator decoupler (OAD) pulley seal cap (A) by piercing the center of the rubber cap with a flat screwdriver and prying it loose. NOTE: While the cap is off, the grease inside the OAD pulley is exposed. Do not wipe ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0081