Honda Odyssey Service Manual: Sliding Door Subseal Replacement

Honda Odyssey Service Manual / Body / Doors and Enclosures / Doors / Vertical and Horizontal Adjustment at the Rear / Sliding Door Subseal Replacement

NOTE: Take care not to scratch the body.

  1. Detach the clip, then remove the subseal (A).

    2. Fastener Location? : Clip, 1AA

  2. Install the subseal in the reverse order of removal, and if the clip is damaged or stress-whitened, replace it with a new one.

    Special Tools Required

    Special Tools Required

    See More:

    Honda Odyssey Service Manual > Front Knuckle/Hub Bearing Unit Replacement: Knuckle Replacement
    Remove the hub bearing unit. Remove the wheel speed sensor (A) from the knuckle (B). Do not disconnect the wheel speed sensor connector. AB6 x 1.0 mm9.3 N·m (0.95 kgf·m, 6.9 lbf·ft) Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B). NOTE: During installation, inst ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0068