Honda Odyssey Service Manual: Power Sliding Door Switch Test/Replacement

Honda Odyssey Service Manual / Body / Doors and Enclosures / Doors / Vertical and Horizontal Adjustment at the Rear / Power Sliding Door Switch Test/Replacement

  1. Remove the driver's middle panel.

  1. Disconnect the 12P connector (A) from the power sliding door switch (B).

    2. 1 2 3 4 5 6 7 8 9 10 1 1 1 2 ABC

  1. Check for continuity between the terminals in each switch position according to the table.

    2. TerminalPosition98LEFTRIGHTOPENCLOSEOPENCLOSE711211106????????????Open/Close Switch:
    TerminalPositionONOFF54??Main Switch:

  2. If the continuity is not as specified, check the bulb(s) (C). If the bulb(s) are OK, replace the switch.

  3. Install the parts in the reverse order of removal.

    Sliding Door Guide Pin Replacement

    Resetting the Power Sliding Door Control Unit/Re-Homing the Power Sliding Doors

    See More:

    Honda Odyssey Service Manual > Front Knuckle/Hub Bearing Unit Replacement: Knuckle Replacement
    Remove the hub bearing unit. Remove the wheel speed sensor (A) from the knuckle (B). Do not disconnect the wheel speed sensor connector. AB6 x 1.0 mm9.3 N·m (0.95 kgf·m, 6.9 lbf·ft) Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B). NOTE: During installation, inst ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0166