Honda Odyssey Service Manual: Driver's Power Tailgate Switch Test/Replacement

Honda Odyssey Service Manual / Body / Doors and Enclosures / Trunklid/Tailgate/Cargo Doors / Driver's Power Tailgate Switch Test/Replacement

  1. Remove the driver's middle panel.

  1. Disconnect the 6P [17P] connector (A) from the driver's power tailgate switch (B).

    [ ]: With parking and back-up sensor system

  2. 1 2 3 4 5 6 7 8 9 1 0 1 1 1 2 1 3 1 4 1 5 1 6 1 7 6 5 4 3 2 1 ABWith parking and back-up sensor systemWithout parking and back-up sensor systemCC
  1. Check for continuity between the terminals in each switch position according to the table.

  2. TerminalPosition452ReleasedPressed[15][14][5]1[3][ ]: With parking and back-up sensor system
  1. With parking and back-up sensor system. If the continuity is not as specified, replace the bulb (C) or driver's power tailgate switch.

  1. Without parking and back-up sensor system: If the continuity is not as specified, replace the bulb (A) or driver's power tailgate switch.

  2. A
  1. Install the switch in the reverse order of removal.

    Trunklid/Tailgate/Cargo Doors

    Power Tailgate Control Unit Input Test/Replacement

    See More:

    Honda Odyssey Owners Manual > Seat Belts: Fastening a Seat Belt
    After adjusting a front seat to the proper position, and while sitting upright and well back in the seat: 1. Pull the seat belt out slowly. 2. Insert the latch plate into the buckle, then tug on the belt to make sure the buckle is secure. ► Make sure that the belt is not twisted or caught on a ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2020 Copyright www.hodyssey.net
    0.0164