Honda Odyssey Service Manual: Power Tailgate Inside Switch Test/Replacement

Honda Odyssey Service Manual / Body / Doors and Enclosures / Trunklid/Tailgate/Cargo Doors / Power Tailgate Inside Switch Test/Replacement

  1. Carefully pry out the inside tailgate switch (A), and disconnect the 5P connector (B) from the switch.

  2. 1 2 3 4 5 ACB
  1. Check for continuity between the terminals in each switch position according to the table.

  2. TerminalPosition4532ReleasedPressed
  3. If the continuity is not as specified, replace the bulbs (C) or the switch.

  1. Install the switch in the reverse order of removal.

Resetting the Power Tailgate Control Unit

If the battery terminal is disconnected or the No. B16 (10 A)   fuse in the under-hood fuse/relay box is removed while the power tailgate is operating, the power tailgate will not be able to open or close automatically until it is reset. To reset the system, fully close the tailgate manually. Once the battery terminals are reconnected or the No. B16 (10 A)   fuse in the under-hood fuse/relay box is replaced, the power tailgate system automatically resets. Make sure the power tailgate operates properly.

    Power Tailgate Control Unit Input Test/Replacement

    Power Tailgate Drive Unit Replacement

    See More:

    Honda Odyssey Service Manual > Body Exterior: Rear Bumper Step Replacement
    Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not to scratch the rear bumper. Use the appropriate tool from the KTC trim tool set to avoid damage when removing compon ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2020 Copyright www.hodyssey.net
    0.0244