Honda Odyssey Service Manual: Power Tailgate Pinch Sensor Replacement

  1. Open the tailgate.

  1. Remove the clips, the screws, the bolts, and the nuts from the pinch sensor (A).

    NOTE: The illustration shows the left side pinch sensor; right side is similar.

  2. AB
  3. Disconnect the 2P connector (B) from the pinch sensor.

  4. Install in the reverse order of removal.

    Power Tailgate Drive Unit Replacement

    Tailgate Support Strut Replacement

    See More:

    Honda Odyssey Service Manual > Front Knuckle/Hub Bearing Unit Replacement: Knuckle Replacement
    Remove the hub bearing unit. Remove the wheel speed sensor (A) from the knuckle (B). Do not disconnect the wheel speed sensor connector. AB6 x 1.0 mm9.3 N·m (0.95 kgf·m, 6.9 lbf·ft) Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B). NOTE: During installation, inst ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0099