Honda Odyssey Service Manual: Front Bulkhead Cover Replacement

Honda Odyssey Service Manual / Body / Body Exterior / Front Bulkhead Cover Replacement

NOTE:

  • Take care not to scratch the front bumper or the body.

  • When prying with a flap-tip screwdriver, wrap it with protective tape to prevent damage.

  1. Remove the air intake scoop.

  1. Detach the clips, then remove the front bulkhead cover (A).

    NOTE: To release the clips, pry up on the center pin at the notch (B).

  2. Fastener Locations? : Clip, 7ABB
  3. Install the cover in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • Push the clips into place securely.

    Rear Bumper Step Replacement

    Rear License Trim Replacement (With Keyless Access)

    See More:

    Honda Odyssey Owners Manual > Audio System: Auxiliary Input Jack
    Use the jack to connect standard audio devices. 1. Open the AUX cover. 2. Connect a standard audio device to the input jack using a 1/8 inch (3.5 mm) stereo miniplug. ► The audio system automatically switches to the AUX mode. To switch the mode, press any of the audio mode buttons. You can ret ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0077