Honda Odyssey Service Manual: Roof Molding Replacement

Honda Odyssey Service Manual / Body / Body Exterior / Roof Molding Replacement

Special Tools Required

  • KTC Trim Tool Set SOJATP2014
  • *Available through the Honda Tool and Equipment Program; call 888-424-6857

NOTE:

  • Take care not to scratch the body.

  • The steel core in the roof molding can not be restored to its original shape once it is bent. Replace the roof molding if the steel core is bent.

  • Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

  1. Remove the roof molding (A).

    1. Detach the clips by prying up the roof molding with the appropriate trim tool.

    1. Release the roof molding from the tailgate hinge cover (B).

  2. Fastener Locations? : Clip, 3AFrontFrontBARight sideLeft side
  1. Install the roof molding in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones. The front clip should be installed on the body with its hook toward the front, and the rear clip should be installed with its hook toward the rear.

    • Make sure the roof molding (A) are installed on the clips (B) securely.

  2. AB
    Rear License Trim Replacement (With Keyless Access)

    Front Inner Fender Replacement

    See More:

    Honda Odyssey Service Manual > Vertical and Horizontal Adjustment at the Rear: Power Sliding Door Switch Test/Replacement
    Remove the driver's middle panel. Disconnect the 12P connector (A) from the power sliding door switch (B). 1 2 3 4 5 6 7 8 9 10 1 1 1 2 ABC Check for continuity between the terminals in each switch position according to the table. TerminalPosition98LEFTRIGHTOPENCLOSEOPENCLOSE711211106????????????Ope ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0093