Honda Odyssey Service Manual: Installation

NOTE: The holes for the mounting screws in a new power window motor are not threaded. The screws cut threads in the holes the first time they are installed.

  1. Install the power window motor (A) onto the regulator (B) as shown, and tighten the screws (C) until the screw head contacts with the linkage.

    NOTE:

    • Keep the screws perfectly straight while screwing them in.

    • Do not use air tools or impact wrenches.

    • Do not use any other screws; these screws are designed to cut the threads.

  2. C5 N?m (0.5 kgf?m, 3.7 lbf?ft)AB
  1. Loosen the screws , and retighten the screws to specified torque.

  1. Install the door glass and regulator.

  1. Install the door panel.

  1. After replacement, reset the power window control unit.

    Removal

    Rear Power Window Motor Replacement

    See More:

    Honda Odyssey Service Manual > Ergonomic Settings: Driving Position Memory Switch Test/Replacement
    Remove the driver's door panel. Disconnect the 10P connector (A) from the driver's position memory switch (B). 6 5 4 3 2 1 10 9 8 7 AB Remove the two screws, then remove the switch from the door panel. Check for continuity between the terminals in each switch position according to the table. NOTE: M ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2020 Copyright www.hodyssey.net
    0.0243