Honda Odyssey Service Manual: Rewriting the ODO Data on a New Gauge Control Module

Honda Odyssey Service Manual / Body / Driver Info & Control / Gauges / Rewriting the ODO Data on a New Gauge Control Module

NOTE:

  • Obtain a new gauge control module before starting the rewriting process. Only new gauges can be rewritten.

  • Rewriting is not possible on a gauge control module that will not communicate with the HDS.

  • Make sure that the HDS shows the correct VIN for the vehicle you are working on.

  • Once you have started this procedure, you must complete it before removing the HDS from the Data Link Connector (DLC).

  • Connect a jumper battery (do not connect a battery charger) to insure that correct battery voltage is maintained.

  • Check any official Honda service website for more service information about the odometer.

Rewriting and Transferring

  1. Before replacing the gauge control module, connect the HDS.

  1. Select GAUGES from the BODY ELECTRICAL SYSTEM SELECT menu with the HDS.

  1. Select Gauge Control Module Replacement (ODO Rewrite) from the ADJUSTMENT menu, and follow the instructions on the display to retrieve the ODO value.

  1. Replace the gauge control module.

  1. Follow the instructions on the display to write the new ODO value on the new gauge control module. If the data transfer fails, refer to the instructions to release the locked ODO value.


    Gauge Control Module Replacement

    How to Release Locked Odometer Mileage to the Original Gauge Control module

    See More:

    Honda Odyssey Service Manual > Speaker Test/Replacement: Door Speaker
    Remove the door panel. Front Sliding door Remove the bolt (A). Then lift the speaker (B) straight up to release the lower clips (C). notice If you pull the speaker out too far from the door, you will damage the lower clips. 2 1 CA5 x 0.8 mm 4.4 N ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2020 Copyright www.hodyssey.net
    0.0166