Honda Odyssey Service Manual: Brake Pedal Position Switch Test/Replacement

Honda Odyssey Service Manual / Chassis / Brakes / Hydraulic Brakes / Brake Pedal Position Switch Test/Replacement

Test

  1. Disconnect the 4P connector (A) from the brake pedal position switch (B).

  2. 1 2 3 4 AB
  1. Check for continuity between the terminals in each switch position according to the table.

  2. TerminalPositionPressedReleased34????12
  3. If the test results are not as specified, do the Brake Pedal and Brake Pedal Position Switch Adjustment, then recheck.
    If the results are still not as specified, replace the switch.


Replacement

  1. Remove the driver's dashboard undercover.

  1. Disconnect the 4P connector (A) from the brake pedal position switch (B).

  2. ABCD
  1. Turn the brake pedal position switch 45° counterclockwise to remove the switch from the pedal bracket (C), then remove the attaching piece (D).

  1. Install a new switch in the reverse of order removal.

  1. Do the Brake Pedal and Brake Pedal Position Switch Adjustment.

    Brake Master Cylinder Inspection

    Parking Brake

    See More:

    Honda Odyssey Service Manual > Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (Canada model): Installation
    NOTE: The MICU which is part of the driver's under-dash fuse/relay box is a component of the immobilizer system. Because of this construction, the MICU must be registered when the driver's under-dash fuse/relay box is replaced, or the vehicle will not start. With keyless access system Instal ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0084