Honda Odyssey Service Manual: Removal

  1. Do the battery terminal disconnection procedure.

  1. Set the front wheels in the straight ahead position, then remove the driver's airbag from the steering wheel.

  1. Disconnect the cable reel subharness connector (A).

  2. B10 x 1.25 mmA
  3. Loosen the steering wheel bolt (B) three turns.

  1. Install the steering wheel puller (A) on the steering wheel (B). Free the steering wheel from the steering column shaft by turning the pressure bolt (C) of the puller.

    Note these items when removing the steering wheel:

    • Do not tap on the steering wheel or the steering column shaft when removing the steering wheel.

    • If you thread the puller bolts (D) into the wheel hub more than five threads, the bolts will hit the cable reel and damage it. To prevent this, install a pair of jam nuts five threads up on each puller bolt.

  2. ABCD
  1. Remove the steering wheel puller, then remove the steering wheel bolt (A) and the steering wheel from the steering column.

  2. A10 x 1.25 mm
    Steering Wheel Removal and Installation

    Installation

    See More:

    Honda Odyssey Service Manual > Navigation and Telematics: Navigation Display Visor Removal/Installation
    NOTE: Do this procedure in a clean place free from dirt. Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves). When removing the navigation display visor, do not touch the LCD facing. If there is dirt on the LCD facing, clean it using compressed air. When installing the na ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0118