Honda Odyssey Service Manual: Exploded View

Honda Odyssey Service Manual / Chassis / Suspension / Rear Knuckle/Hub Bearing Unit Replacement / Exploded View

12 x 1.25 mm98 N·m(10.0 kgf·m, 72 lbf·ft)14 x 1.5 mm78 N·m(8.0 kgf·m, 58 lbf·ft)KNUCKLECheck for deformation and damage.WASHERCheck for deformation and damage.HUB BEARING UNIT(MAGNETIC ENCODER)Check for faultymovement and wear.REAR BRAKE DISC/DRUMCheck for wear and rust.FLATHEAD SCREW6 x 1.0 mm9.3 N·m(0.95 kgf·m,6.9 lbf·ft)BACKING PLATECheck for corrosion, deformation, rust, and damage.PARKING BRAKE SHOE ASSEMBLYO-RING Replace.

Special Tools Required

  • Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
  • Ball Joint Remover, 28 mm 07MAC-SL0A202

NOTE: Refer to the Exploded View as needed during the following procedure.

    Rear Knuckle/Hub Bearing Unit Replacement

    Hub Bearing Unit Replacement

    See More:

    Honda Odyssey Service Manual > Power Seat Controls: Power Lumbar Support Switch Test/Replacement
    NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. Remove the driver's recline cover. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B). 1 2 3 4 5 A ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0144