Honda Odyssey Service Manual: Front Stabilizer Bar Replacement

Honda Odyssey Service Manual / Chassis / Suspension / Front Stabilizer Bar Replacement

  1. Raise and support the vehicle.

  1. Remove the front wheels.

  1. Disconnect both sides of the stabilizer link from the stabilizer bar.

  1. Detach the clips (B) from mounting bracket A, then move mounting bracket A aside.

  2. AB
  1. Remove the flange bolts (A) and the bushing holders (B), then remove the bushings (C).

  2. A10 x 1.25 mm39 N·m (4.0 kgf·m, 29 lbf·ft)FRONTCB
  3. Move the stabilizer bar toward the passenger's side, and remove the stabilizer bar.


  4. Install all of the removed parts in the reverse order of removal, and note these items:

    • Note the direction of installation for the bushings.

    • Refer to stabilizer link removal/installation to connect the stabilizer bar to the links.

    • Before installing the wheel, clean the mating surfaces between the brake disc and the inside of the wheel.

    Installation

    Brake Control and Vehicle Dynamics

    See More:

    Honda Odyssey Service Manual > Seat Position Sensors: Driver's Seat Position Sensor Operation Check
    NOTE: Check the driver's seat position sensor operation after the driver's seat position sensor replacement or removal. Make sure the driver's seat is in the full forward position. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode. Connect the HDS to ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2021 Copyright www.hodyssey.net
    0.0281