1. Park the vehicle on a level surface, and set
the parking brake. 3. Slide the hood latch lever in the center of the hood to release the lock mechanism, and open the hood. 4. Remove the support rod from the clamp using the grip. Mount the support rod in the hood. When closing, remove the support rod, and stow it in the clamp, then gently lower the hood. Remove your hand at a height of approximately 12 inches (30 cm) and let the hood close. NOTICE Do not open the hood when the wiper arms are raised. The hood will strike the wipers, and may damage either the hood or the wipers. When closing the hood, check that the hood is securely latched. If the hood latch lever moves stiffly, or if you can open the hood without lifting the lever, the latch mechanism should be cleaned and lubricated. |
Honda Odyssey Service Manual > Body Exterior: Front Bulkhead Cover Replacement
NOTE: Take care not to scratch the front bumper or the body. When prying with a flap-tip screwdriver, wrap it with protective tape to prevent damage. Remove the air intake scoop. Detach the clips, then remove the front bulkhead cover (A). NOTE: To release the clips, pry up on the center pin at the n ...