Driver’s side 1. Remove the clips using a flat-tip screwdriver, then remove the upper part of the air intake duct. Passenger’s side 1. Remove the clips using a flat-tip screwdriver, then remove the engine coolant reservoir out of its stay. Remove the power steering reservoir from the stay bracket. Holding clip Insert a flat-tip screwdriver, lift and remove the central pin to remove the clip. Insert the clip with the central pin raised, and push until it is flat. 2. Remove the coupler. |
Honda Odyssey Service Manual > Vertical and Horizontal Adjustment at the Rear: Special Tools Required
KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: If you remove the door upper molding, replace it with a new one because it will bend during removal. Put on gloves to protect your hands. Take care not to scratch the door. Use the appropri ...