Honda Odyssey Service Manual: BSI Control Unit Removal/Installation

Honda Odyssey Service Manual / Accessories / Driver Assist / Blind Spot Monitor / BSI Control Unit Removal/Installation

  1. Remove the left rear side trim panel.

  1. Remove the BSI control unit (A).

    1. Disconnect the BSI control unit 16P connector (B) and detach the harness clip (C).

    1. Remove the bolt.

    2. BCA9.4 N·m(0.96 kgf·m,6.9 lbf·ft)

  2. Install the BSI control unit in the reverse order of removal.

    Blind Spot Monitor

    BSI OFF Switch Test/Removal/Installation

    See More:

    Honda Odyssey Service Manual > Crash Sensors: Yaw Rate-Acceleration Sensor Replacement
    NOTE: Do not damage or drop the sensor as it is sensitive. Do not use power tools when replacing the sensor. Check the sensor bracket for a deformation. Turn the ignition switch to LOCK (0). Remove the center lower console. Remove the yaw rate-acceleration sensor (A). AB6 x 1.0 mm9.4 N·m (0.96 kgf ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0065