Honda Odyssey Service Manual: BSI OFF Switch Test/Removal/Installation

Honda Odyssey Service Manual / Accessories / Driver Assist / Blind Spot Monitor / BSI OFF Switch Test/Removal/Installation

  1. Push out the BSI OFF switch (A) from the back of the dashboard, and disconnect the BSI OFF switch 6P connector (B).

  2. AB
  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminal in each switch position according to the table.

  2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals
    TerminalPosition45PRESSEDRELEASED
  • If the switch does not work as described in the table, replace the switch.

  • If the switch tests OK, go to step 3.

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminals No. 1 and No. 2.   There should be continuity at all times.

  2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals?
  1. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

  2. BA
  1. Install the BSI OFF switch in the reverse order of removal.

    BSI Control Unit Removal/Installation

    BSI Radar Unit Aiming Inspection

    See More:

    Honda Odyssey Owners Manual > Child Safety: Safety of Larger Children
    WARNING Allowing a child age 12 or under to sit in front can result in injury or death if the passenger's front airbag inflates. If a larger child must ride in front, move the vehicle seat as far to the rear as possible, have the child sit up properly and wear the seat belt properly, using a booster ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0082