Honda Odyssey Service Manual: HandsFreeLink Control Unit Removal/Installation

Honda Odyssey Service Manual / Accessories / Personal Communications / HandsFreeLink Control Unit Removal/Installation

NOTE: Tell the customer they need to write down all phone numbers stored in the HFL and the navigation imported phone book as there is no way to transfer the information in the original HandsFreeLink control unit to a new HandsFreeLink control unit.

  1. Remove the center middle panel.

  1. Remove the passenger's middle panel.

  1. Remove the center panel.

  1. Remove the center lower console.

  1. With navigation, remove the audio-navigation unit assembly.

  1. Without navigation, remove the audio unit assembly:

    • With touch screen

    • Without touch screen

  1. Remove the screws, then disconnect the connectors (A) and (B) from the HandsFreeLink control unit (C), and remove it.

  2. ACB (with touch screen)
  3. Install the HandsFreeLink control unit in the reverse order of removal.

    After replacing the HandsFreeLink control unit, tell the customer:

    • They need to pair their cell phones to the system.

    • They need to set up their system preferences.

    HDD Removal/Installation

    Rear Controller and Screen Removal/Installation

    See More:

    Honda Odyssey Service Manual > Crash Sensors: Side Impact Sensor (Second) Replacement
    Removal Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work. Remove the sliding door sill trim. Disconnect the side impact sensor (second) 2P connector (A) on the left or right wire harness. ABC Remove the TORX bolt (B) using a TORX T30 bit, then remove ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0075