Immobilizer Function The vehicle is disables the vehicle unless a programmed remote is used. This system consists of a transponder built into the remote, the engine start/stop switch (has a built-in receiver), the MICU (has a built-in imoes unit), an immobilizer indicator, and the PCM. When the remote (programmed by the HDS) touching the engine start/stop switch and press the engine start/stop switch to select the ON mode, the keyless access control unit sends power to the transponder. The transponder then sends a coded signal back to the keyless access control unit, which then sends a coded signal to the PCM and the MICU (imoes unit). The PCM and MICU (imoes unit) identify this coded signal, then voltage is supplied to the fuel pump. If the wrong remote is used or the code was not received or recognized by the units, the indicator flashes once, then it blinks until the OFF mode is selected by pressing the engine start/stop button. When the OFF mode is selected by pressing the engine start/stop button, the indicator blinks 10 times to signal that unit has reset correctly, then the indicator goes off. Keyless Buzzer Replacement
|
Honda Odyssey Service Manual > Body Interior: Audio Display Visor Removal/Installation
NOTE: Do this procedure in a clean place free from dirt. Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves). When removing the audio display visor, do not touch the LCD facing. If there is dirt on the LCD facing, clean it using compressed air. When installing the audio d ...