Honda Odyssey Service Manual: Sliding Door Assembly

Honda Odyssey Service Manual / Body / Doors and Enclosures / Doors / Sliding Door Assembly

Sliding Door Position Adjustment

NOTE: If equipped, make sure to disable the power sliding door by turning the power sliding door main switch off.

  1. Place the vehicle on a firm, level surface when adjusting the doors.

  1. Remove the bolts (A), and remove both female guides (B) from the body.

    2. BA6 x 1.0 mm7.4 N·m(0.75 kgf·m, 5.4 lbf·ft)BA6 x 1.0 mm7.4 N·m(0.75 kgf·m, 5.4 lbf·ft)
    Sliding Door Latch Remote Control Assembly Replacement

    Vertical Adjustment at the Front

    See More:

    Honda Odyssey Service Manual > Front Knuckle/Hub Bearing Unit Replacement: Knuckle Replacement
    Remove the hub bearing unit. Remove the wheel speed sensor (A) from the knuckle (B). Do not disconnect the wheel speed sensor connector. AB6 x 1.0 mm9.3 N·m (0.95 kgf·m, 6.9 lbf·ft) Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B). NOTE: During installation, inst ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0129