Honda Odyssey Service Manual: Vertical and Horizontal Adjustment at the Rear

Honda Odyssey Service Manual / Body / Doors and Enclosures / Doors / Vertical and Horizontal Adjustment at the Rear

  1. Adjust the center roller (A), the front striker (B) and the rear striker (C).

    1. Loosen the center roller bolts (D).

    1. Move the door in or out until it is flush with the body, and up or down to equalize the gaps.

    1. If necessary, adjust the door cushion (E) to make the door fit flush with the body.

    1. Tighten all bolts securely.

  2. 8 x 1.25 mm18 N·m(1.8 kgf·m, 13 lbf·ft)8 x 1.25 mm18 N·m(1.8 kgf·m, 13 lbf·ft)BCEAD8 x 1.25 mm30 N·m(3.1 kgf·m, 22 lbf·ft)
  1. Set the female guides (A), and lightly tighten the bolts (B). Adjust the alignment of the guides by closing the door, then open the door and tighten the bolts.

  2. AB6 x 1.0 mm7.4 N·m(0.75 kgf·m, 5.4 lbf·ft)AB6 x 1.0 mm7.4 N·m (0.75 kgf·m, 5.4 lbf·ft)
  3. Make sure the door opens and closes smoothly, and locks securely.

  1. Check for water leaks.

Horizontal Adjustment at the Front

Special Tools Required

See More:

Honda Odyssey Service Manual > Hydraulic Brakes: Brake Hose Replacement
notice Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water. NOTE: Before reassembling, check that all parts are free of dirt and other foreign particles. Replace parts with new ones whenever specified to do so. After ...

Honda Odyssey Owners Manual

Honda Odyssey Service Manual

© 2018-2025 Copyright www.hodyssey.net
0.015