Honda Odyssey Service Manual: Power Sliding Door Switch Test/Replacement

Honda Odyssey Service Manual / Body / Doors and Enclosures / Doors / Vertical and Horizontal Adjustment at the Rear / Power Sliding Door Switch Test/Replacement

  1. Remove the driver's middle panel.

  1. Disconnect the 12P connector (A) from the power sliding door switch (B).

    2. 1 2 3 4 5 6 7 8 9 10 1 1 1 2 ABC

  1. Check for continuity between the terminals in each switch position according to the table.

    2. TerminalPosition98LEFTRIGHTOPENCLOSEOPENCLOSE711211106????????????Open/Close Switch:
    TerminalPositionONOFF54??Main Switch:

  2. If the continuity is not as specified, check the bulb(s) (C). If the bulb(s) are OK, replace the switch.

  3. Install the parts in the reverse order of removal.

    Sliding Door Guide Pin Replacement

    Resetting the Power Sliding Door Control Unit/Re-Homing the Power Sliding Doors

    See More:

    Honda Odyssey Service Manual > Vertical and Horizontal Adjustment at the Rear: Sliding Door Lower Roller Assembly Removal/Installation
    NOTE: Put on gloves to protect your hands. Take care not to scratch the door, the body or the related parts. Pad a floor jack (A) with a rubber pad (B), then use the jack to support the door. AB Remove the lower roller plate. Remove the lower roller assembly (A). Remove the bolts with a TORX T40 bit ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0238