Honda Odyssey Service Manual: Power Tailgate Drive Unit Replacement

Honda Odyssey Service Manual / Body / Doors and Enclosures / Trunklid/Tailgate/Cargo Doors / Power Tailgate Drive Unit Replacement

  1. Remove the C-pillar trim.

  1. Remove the upper trim and the left tailgate side trim.

  1. Note the alignment marks on the drive unit and the arm unit, then carefully remove the two bolts (A), nut (B), and the arm unit (C).

    2. CB12 x 1.25 mm109.0 N·m (11.11 kgf·m, 80.41 lbf·ft)A2.2 N·m (2.2 kgf·m, 16.0 lbf·ft)

  1. Disconnect the connectors (A), and remove the three bolts (B) and the drive unit (C).

    2. BAC

  1. Install in the reverse order of removal.

    NOTE: Align the marks (A) of the drive unit and arm unit to install the arm unit to the original alignment.

    2. A
    Power Tailgate Inside Switch Test/Replacement

    Power Tailgate Pinch Sensor Replacement

    See More:

    Honda Odyssey Service Manual > Secondary: Checking and Adjusting the Headliner/Pillar Trim Overlap
    To prevent the side curtain airbag from deploying and damaging the pillar trim (A-pillar trim, B-pillar trim, C-pillar trim, D-pillar trim), the overlap between the headliner and pillar trim must be less than 8 mm(0.31 in)   To check the overlap, do this: NOTE: This illustration shows the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0109