Honda Odyssey Service Manual: Side Sill Panel Replacement

Honda Odyssey Service Manual / Body / Body Exterior / Side Sill Panel Replacement

NOTE: Take care not to scratch the body.

  1. Open the front door and sliding door.

  1. Remove the side sill panel (A).

    1. Canada models: Remove the screws (B), then remove the front splash guard (C).

    1. Remove the screws (D).

    1. Remove the clips (E).

    1. Slide the side sill panel forward. The side clips (F) and the grommet (G) will stay in the body.

    1. Remove the side clips by turning them 45 °.

    2. Fastener LocationsD ? : Screw, 5E ? : Clip, 1 FDAF??F ? : Clip, 14DFDFFFFFFFFFDDEFrontGGB ? : Screw, 4BBBBCFFFCanada models??

  2. If the clips are damaged or stress-whitened, replace them with new ones.

  3. Install the side clips on the side sill panel.

  4. Remove the grommet from the body, then install the grommet to the clips on the side sill panel.

  5. Hold the panel up, and fit all the side clips into the holes in the body, then push on the panel until the side clips snap into place.

  6. Canada models: Reinstall the front splash guard.

  7. Reinstall the screws.

    Rear Air Outlet Replacement

    Front Bumper Removal/Installation

    See More:

    Honda Odyssey Service Manual > Compass: Zone Selection
    Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode. Make sure the center display is in the main screen of any function. Press and hold the ENTER on the center switch panel for about 5 seconds. The center display shows the Compass settings main menu. BACK ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0112