Honda Odyssey Service Manual: Front Bulkhead Cover Replacement

Honda Odyssey Service Manual / Body / Body Exterior / Front Bulkhead Cover Replacement

NOTE:

  • Take care not to scratch the front bumper or the body.

  • When prying with a flap-tip screwdriver, wrap it with protective tape to prevent damage.

  1. Remove the air intake scoop.

  1. Detach the clips, then remove the front bulkhead cover (A).

    NOTE: To release the clips, pry up on the center pin at the notch (B).

    2. Fastener Locations? : Clip, 7ABB

  2. Install the cover in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • Push the clips into place securely.

    Rear Bumper Step Replacement

    Rear License Trim Replacement (With Keyless Access)

    See More:

    Honda Odyssey Owners Manual > When Driving: VSA® (Vehicle Stability Assist), aka ESC (Electronic Stability Control), System
    VSA® helps to stabilize the vehicle during cornering if the vehicle turns more or less than what was intended. It also assists in maintaining traction on slippery surfaces. It does so by regulating engine output and selectively applying the brakes. The VSA® may not function properly if tire type a ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.009