Honda Odyssey Service Manual: Rear Inner Fender Replacement

Honda Odyssey Service Manual / Body / Body Exterior / Rear Inner Fender Replacement

NOTE:

  • Put on gloves to protect your hands.

  • Take care not to scratch the body or the rear bumper.

  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

  1. Remove the rear wheel.

  1. Remove the rear inner fender (A).

    1. Remove the screws (B) and the bolts (C).

    1. Detach the clips (D, E).

    1. Remove the nut (F).

    2. Fastener LocationsA6 x 1.0 mm9.3 N·m(0.95 kgf·m, 6.9 lbf·ft)BBECBBCCB ? : ScrewC ? : Bolt, 5E ? : Clip, 3D ? : Clip, 1FBCEECDB(Left side)Left, 6Right, 5F ? : Clip, 1

  2. Install the inner fender in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • Push the clips into place securely.

    Front Inner Fender Replacement

    Front Door Glass Outer Weatherstrip Replacement

    See More:

    Honda Odyssey Service Manual > Ventilation Doors: Rear Mode Control Motor Replacement
    SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service. Remove the rear HVAC unit. Disconnect the 7P connector (A) from the rear mode control motor (B). Remove the self-tapping screws and ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0157