Honda Odyssey Service Manual: Installation

Honda Odyssey Service Manual / Body / Glass & Windows / Window Control / Installation

NOTE: The holes for the mounting screws in a new power window motor are not threaded. The screws cut threads in the holes the first time they are installed.

  1. Install the power window motor (A) onto the regulator (B) as shown, and tighten the screws (C) until the screw head contacts with the linkage.

    NOTE:

    • Keep the screws perfectly straight while screwing them in.

    • Do not use air tools or impact wrenches.

    • Do not use any other screws; these screws are designed to cut the threads.

    2. C5 N?m (0.5 kgf?m, 3.7 lbf?ft)AB

  1. Loosen the screws , and retighten the screws to specified torque.

  1. Install the door glass and regulator.

  1. Install the door panel.

  1. After replacement, reset the power window control unit.

    Removal

    Rear Power Window Motor Replacement

    See More:

    Honda Odyssey Service Manual > Power Seat Controls: Power Lumbar Support Switch Test/Replacement
    NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. Remove the driver's recline cover. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B). 1 2 3 4 5 A ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0123