Honda Odyssey Service Manual: Center Display Lens Removal/Installation

Honda Odyssey Service Manual / Body / Driver Info & Control / Center Display Lens Removal/Installation

NOTE:

  • Do this procedure in a clean place free from dirt and dust.

  • Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).

  • When removing the center display lens, do not touch the LCD facing.

  • If there is dirt on the LCD facing, blow it clean with compressed air.

  • When installing the center display lens onto the LCD assembly, be careful not to touch the LCD facing.

  • Check that the center display lens and the LCD assembly are properly installed.

  • Check that the center display unit assembly has no damage.

  • When removing the center display lens, do not hold the LCD facing down.

  1. Remove the center display unit.

  1. Remove the screws and the LCD assembly (A) from the center display lens (B).

  2. AB
  3. Install the center display lens reverse order of removal.

    Driver Info & Control

    Compass

    See More:

    Honda Odyssey Service Manual > Lane Departure Warning: Aiming (Service Point Calibration)
    NOTE: Do the service calibration on a flat and straight road that has several lanes where you can drive at least 25 mph (40 km/h). You must complete the aiming procedure within 10 minutes. The aiming procedure may fail if you take too long, if the weather is poor (rain, fog, or snow), or the white o ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0062