Honda Odyssey Service Manual: Dashboard/Steering Hanger Beam Removal/Installation

Honda Odyssey Service Manual / Body / Body Interior / Dashboard Assembly / Dashboard/Steering Hanger Beam Removal/Installation

Special Tools Required

  • KTC Trim Tool Set SOJATP2014
  • *Available through the Honda Tool and Equipment Program; call 888-424-6857

SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service.

NOTE:

  • Have an assistant help you when removing and installing the dashboard.

  • Put on gloves to protect your hands.

  • Take care not to scratch the dashboard, the body or the related parts.

  • Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before beginning work.

  1. Remove these items from the dashboard:

    • Detachable console

    • A-pillar upper/lower trims, both sides

    • Dashboard side lids, both sides

    • Kick panels, both sides

    • Column blind cover

    • Steering column

    • Center lower console

    • Glove box

    • Passenger's dashboard undercover

  1. Disconnect the A/T shift cable.


    Dashboard Passenger's Middle Panel Removal/Installation

    Driver's Side

    See More:

    Honda Odyssey Service Manual > Rear Knuckle/Hub Bearing Unit Replacement: Knuckle Replacement
    Remove the hub bearing unit. Remove the flange nuts (A), then remove the backing plate (B) with the parking brake shoe assembly. To prevent damage to the backing plate with the parking brake shoes assembly and parking brake cable, use a short piece of wire to hang the backing plate from the undercar ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2022 Copyright www.hodyssey.net
    0.0064