Honda Odyssey Service Manual: Driver's Side

Honda Odyssey Service Manual / Body / Body Interior / Dashboard Assembly / Driver's Side

  1. Disconnect the roof wire harness connector (A) from the A-pillar.

    2. A

  1. From under the dash, disconnect the following connectors:

    • Left side wire harness connectors (A)

    • Left engine compartment wire harness connectors (B)

    • Driver's door wire harness connectors (C)

    2. AABBC

  1. From under the dash, remove the mounting bolts.

    2. Fastener Locations? : Bolt, 28 x 1.25 mm22 N·m(2.2 kgf·m, 16 lbf·ft)

    Dashboard/Steering Hanger Beam Removal/Installation

    Middle Area

    See More:

    Honda Odyssey Service Manual > Trunklid/Tailgate/Cargo Doors: Power Tailgate Drive Unit Replacement
    Remove the C-pillar trim. Remove the upper trim and the left tailgate side trim. Note the alignment marks on the drive unit and the arm unit, then carefully remove the two bolts (A), nut (B), and the arm unit (C). CB12 x 1.25 mm109.0 N·m (11.11 kgf·m, 80.41 lbf·ft)A2.2 N·m (2.2 kgf·m, 16.0 lbf ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0122