Honda Odyssey Service Manual: BSI Control Unit Removal/Installation

Honda Odyssey Service Manual / Body / Restraints / Restraints Control / BSI Control Unit Removal/Installation

  1. Remove the left rear side trim panel.

  1. Remove the BSI control unit (A).

    1. Disconnect the BSI control unit 16P connector (B) and detach the harness clip (C).

    1. Remove the bolt.

  2. BCA9.4 N·m(0.96 kgf·m,6.9 lbf·ft)
  3. Install the BSI control unit in the reverse order of removal.

    Restraints Control

    BSI OFF Switch Test/Removal/Installation

    See More:

    Honda Odyssey Service Manual > Keyless Security System: Immobilizer Function, Keyless Buzzer Replacement
    Immobilizer Function The vehicle is disables the vehicle unless a programmed remote is used. This system consists of a transponder built into the remote, the engine start/stop switch (has a built-in receiver), the MICU (has a built-in imoes unit), an immobilizer indicator, and the PCM. When the remo ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.007