Honda Odyssey Service Manual: BSI OFF Switch Test/Removal/Installation

Honda Odyssey Service Manual / Body / Restraints / Restraints Control / BSI OFF Switch Test/Removal/Installation

  1. Push out the BSI OFF switch (A) from the back of the dashboard, and disconnect the BSI OFF switch 6P connector (B).

  2. AB
  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminal in each switch position according to the table.

  2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals
    TerminalPosition45PRESSEDRELEASED
  • If the switch does not work as described in the table, replace the switch.

  • If the switch tests OK, go to step 3.

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminals No. 1 and No. 2.   There should be continuity at all times.

  2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals?
  1. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

  2. BA
  1. Install the BSI OFF switch in the reverse order of removal.

    BSI Control Unit Removal/Installation

    LaneWatch   System

    See More:

    Honda Odyssey Service Manual > Mirrors: Mirror Holder Replacement
    NOTE: Put on gloves to protect your hands. When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. Carefully push on the top edge of the mirror holder (A) by hand. BAC Put a shop towel in the opening between the bottom edge of the mirror holder and the mirror housing ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0077