Honda Odyssey Service Manual: Side Impact Sensor (Second) Replacement

Honda Odyssey Service Manual / Body / Restraints / Restraints Control / Crash Sensors / Side Impact Sensor (Second) Replacement

Removal

  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

  1. Remove the sliding door sill trim.

  1. Disconnect the side impact sensor (second) 2P connector (A) on the left or right wire harness.

    2. ABC

  2. Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (second) (C).


Installation

  1. Install the side impact sensor (second) (A) with the new TORX bolt (B) using a TORX T30 bit, and tighten the TORX bolt to the specified torque.

    2. ACB11 N·m (1.1 kgf·m, 8 lbf·ft)Replace.

  2. Connect the side impact sensor (second) 2P connector (C) on the left or right wire harness.

  3. Do the battery terminal reconnection procedure.

  4. Clear any DTCs with the HDS.

  5. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

  6. Install the sliding door sill trim.

    Rear Safing Sensor Replacement

    Side Impact Sensor (Third) Replacement

    See More:

    Honda Odyssey Service Manual > Data and Communication Network: Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (USA model)
    Special Tools Required Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0 USA models NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. Removal Do the battery terminal disconnection procedure. Remo ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0116