Honda Odyssey Service Manual: Lumbar Support

Honda Odyssey Service Manual / Body / Seating / Lumbar Support

Power Lumbar Support Switch Test/Replacement

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

  1. Remove the driver's recline cover.

  1. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B).

    2. 1 2 3 4 5 AB

  1. Check for continuity between the terminals in each switch position according to the table.

    2. ForwardBackwardTerminalPosition12345*???????*?

    *: There is continuity without operating a switch.

  2. If the continuity is not as specified, replace the switch.

  3. Install the switch in the reverse order of removal.

    Headrests

    Seat Controls

    See More:

    Honda Odyssey Service Manual > Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (USA model): Installation
    NOTE: The MICU which is part of the driver's under-dash fuse/relay box is a component of the immobilizer system. Because of this construction, the MICU must be registered when the driver's under-dash fuse/relay box is replaced, or the vehicle will not start. With keyless access system Instal ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0061