Honda Odyssey Service Manual: Power Lumbar Support Switch Test/Replacement

Honda Odyssey Service Manual / Body / Seating / Seat Controls / Power Seat Controls / Power Lumbar Support Switch Test/Replacement

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

  1. Remove the driver's recline cover.

  1. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B).

    2. 1 2 3 4 5 AB

  1. Check for continuity between the terminals in each switch position according to the table.

    2. ForwardBackwardTerminalPosition12345*???????*?

    *: There is continuity without operating a switch.

  2. If the continuity is not as specified, replace the switch.

  3. Install the switch in the reverse order of removal.

    Power Seat Controls

    Power Seat Control Unit Input Test/Replacement

    See More:

    Honda Odyssey Service Manual > Dashboard Assembly: Driver's Side
    Disconnect the roof wire harness connector (A) from the A-pillar. A From under the dash, disconnect the following connectors: Left side wire harness connectors (A) Left engine compartment wire harness connectors (B) Driver's door wire harness connectors (C) AABBC From under the dash, remove the mou ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0109