Honda Odyssey Service Manual: Minor Adjustment

  1. Raise and support the vehicle.

  1. Release the parking brake pedal fully.

  1. Press the parking brake pedal 1 click.

  1. Tighten the adjusting nut (A) until the parking brakes drag slightly when the rear wheels are turned.

  2. A
  3. Release the parking brake pedal fully, and check that the parking brakes do not drag when the rear wheels are turned. Readjust if necessary.

  4. Make sure the parking brake pedal is within the specified number of clicks (8 to 10 clicks).


Major Adjustment (to be done when replacing parking brake shoes and after lining surface break-in)

  1. Raise and support the vehicle.

  1. Release the parking brake pedal fully.

  1. Loosen the adjusting nut (A).

  2. A
  3. Remove the rear wheels.


  1. Remove the access plug (A).

  2. ABC
  3. Turn the ratchet teeth on the adjuster nut (B) with a brake adjuster tool or a flat-tip screwdriver (C) until the shoes lock against the parking brake drum. Then back off the adjuster 15 clicks, and install the access plug.

  4. Clean the mating surfaces between the brake disc/drum and the inside of the wheel, then install the rear wheels.

  5. Do the minor adjustment procedure.

    Parking Brake Inspection and Adjustment

    Parking Brake Cable Replacement

    See More:

    Honda Odyssey Service Manual > Gauges: Gauge Control Module Replacement
    NOTE: Before replacing the gauge control module, retrieve the ODO data from the gauge control module with the HDS. Turn the ignition switch to LOCK (0). Remove the instrument visor. Remove the three screws from the gauge control module (A). BA Disconnect the 32P connector (B) from the gauge control ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0126