Honda Odyssey Service Manual: Hydraulic Power Steering Hose, Line, and Pressure Switch Replacement

Honda Odyssey Service Manual / Chassis / Steering / Hydraulic Power Steering Hose, Line, and Pressure Switch Replacement

Note these items during installation:

  • Connect each hose to the corresponding line securely until it contacts the stop on the line. Install the clamp or adjustable clamp at the specified distance from the hose end as shown.

  • Check all clamps for deterioration or deformation; replace the clamps with new ones if necessary.

  • Add the recommended power steering fluid to the specified level on the reservoir, and check for leaks.

ADJUSTABLE HOSE CLAMP (A)HOSE CLAMP (B)2.5-5.5 mm(0.098-0.216 in)2.0-4.0 mm(0.079-0.157 in)2.5-5.5 mm(0.098-0.216 in)
RETURN LINE JOINT16 x 1.5 mm29 N·m(3.0 kgf·m, 21 lbf·ft)POWER STEERINGPRESSURE SWITCH12 N·m(1.2 kgf·m, 9 lbf·ft)CYLINDER LINES15 N·m (1.5 kgf·m, 11 lbf·ft)INLET LINE JOINT14 x 1.5 mm37 N·m(3.8 kgf·m, 27 lbf·ft)PUMP INLET HOSE6 x 1.0 mm11 N·m(1.1 kgf·m, 8 lbf·ft)PUMP OUTLET HOSERETURN HOSECYLINDER LINES15 N·m (1.5 kgf·m, 11 lbf·ft)BARETURN HOSEAARETURN LINE6 x 1.0 mm9.5 N·m(0.97 kgf·m, 7.0 lbf·ft)6 x 1.0 mm9.5 N·m(0.97 kgf·m, 7.0 lbf·ft)B
    Hydraulic Power Steering Fluid Leakage Inspection

    Hydraulic Power Steering Pump Overhaul

    See More:

    Honda Odyssey Service Manual > Rear Spring/Bump Stop Removal/Installation: Removal
    Raise and support the vehicle. Remove the rear wheel. Position a floor jack under lower arm B. Raise the floor jack until the suspension begins to compress. BA14 x 1.5 mmReplace. Remove the flange bolt (A) from the knuckle. Lower the floor jack gradually. Remove the spring (A), the spring mounting c ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0114