Honda Odyssey Service Manual: Exploded View

Honda Odyssey Service Manual / Chassis / Steering / Hydraulic Power Steering Pump Overhaul / Exploded View

8 x 1.25 mm20 N·m (2.0 kgf·m, 15 lbf·ft)PUMP COVER3 mm ROLL PIN2 mm ROLL PINPUMP COVER SEALReplace.CAM RINGVANES(11 plates)ROTOR23.8 x 2.4 mmO-RINGReplace.SIDE PLATEOUTER CASE57.2 x 1.9 mm O-RINGReplace.12.7 x 1.8 mm O-RINGReplace.INLET JOINT6 x 1.0 mm11 N·m (1.1 kgf·m, 8 lbf·ft)FLOW CONTROL VALVE SPRING16.7 x 1.8 mm O-RINGReplace.PUMP HOUSINGPUMP SEALReplace.BALL BEARING40 mm SNAP RINGDRIVESHAFTPULLEYPULLEY NUT64 N·m(6.5 kgf·m, 47 lbf·ft)FLOW CONTROL VALVE CAP49 N·m (5.0 kgf·m, 36 lbf·ft)FLOW CONTROL VALVEPUMP HOUSING CAP29 N·m (3.0 kgf·m, 22 lbf·ft)PUMP PRELOAD SPRING14.8 x 1.9 mm O-RINGReplace.RUBBER SEAL (Black color)Replace.SLIPPER SEAL (White color)Replace.13.0 x 1.9 mm O-RINGReplace.

Special Tools Required

  • Pulley Holder 07ZAB-S5A0100
  • Driver Handle, 15 x 135L 07749-0010000
  • Bearing Driver Attachment, 32 x 35 mm 07746-0010100

NOTE: Refer to the Exploded View as needed during the following procedure.

    Hydraulic Power Steering Pump Overhaul

    Disassembly

    See More:

    Honda Odyssey Service Manual > Ergonomic Settings: Driving Position Memory Switch Test/Replacement
    Remove the driver's door panel. Disconnect the 10P connector (A) from the driver's position memory switch (B). 6 5 4 3 2 1 10 9 8 7 AB Remove the two screws, then remove the switch from the door panel. Check for continuity between the terminals in each switch position according to the table. NOTE: M ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0121