Install the spring (A), spring mounting cushion (C), and the
lower spring seat (D). Align the bottom of the spring with the stepped
part of the lower spring seat and lower arm B as shown.
Position a floor jack under lower arm B. Raise the floor jack
until the hole in lower arm B aligns with the hole in the knuckle, then
loosely install the new flange bolt (A) to the knuckle.
Raise the rear suspension with the floor jack to load the suspension with the vehicle's weight.
Tighten the flange bolt to the specified torque.
Clean the mating surfaces between the brake disc/drum and the inside of the wheel, then install the rear wheel.
Check the wheel alignment, and adjust it if necessary.
Honda Odyssey Service Manual > Hydraulic Brakes: Brake Booster Replacement
Remove the air cleaner. Remove the master cylinder. Remove the brake lines (A) from the VSA modulator-control unit (B). A22 N·m(2.2 kgf·m,16 lbf·ft)BC Disconnect the brake booster vacuum hose (C) from the brake booster. Remove the lock pin (A) and the clevis pin (B), then disconnect the clevis fr ...