Honda Odyssey Service Manual: Exploded View

Honda Odyssey Service Manual / Chassis / Suspension / Rear Knuckle/Hub Bearing Unit Replacement / Exploded View

12 x 1.25 mm98 N·m(10.0 kgf·m, 72 lbf·ft)14 x 1.5 mm78 N·m(8.0 kgf·m, 58 lbf·ft)KNUCKLECheck for deformation and damage.WASHERCheck for deformation and damage.HUB BEARING UNIT(MAGNETIC ENCODER)Check for faultymovement and wear.REAR BRAKE DISC/DRUMCheck for wear and rust.FLATHEAD SCREW6 x 1.0 mm9.3 N·m(0.95 kgf·m,6.9 lbf·ft)BACKING PLATECheck for corrosion, deformation, rust, and damage.PARKING BRAKE SHOE ASSEMBLYO-RING Replace.

Special Tools Required

  • Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
  • Ball Joint Remover, 28 mm 07MAC-SL0A202

NOTE: Refer to the Exploded View as needed during the following procedure.

    Rear Knuckle/Hub Bearing Unit Replacement

    Hub Bearing Unit Replacement

    See More:

    Honda Odyssey Service Manual > Blind Spot Monitor: BSI Control Unit Removal/Installation
    Remove the left rear side trim panel. Remove the BSI control unit (A). Disconnect the BSI control unit 16P connector (B) and detach the harness clip (C). Remove the bolt. BCA9.4 N·m(0.96 kgf·m,6.9 lbf·ft) Install the BSI control unit in the reverse order of removal. ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0163