Honda Odyssey Service Manual: Exploded View

Honda Odyssey Service Manual / Chassis / Suspension / Front Knuckle/Hub Bearing Unit Replacement / Exploded View

FLANGE NUTReplace.SPLASH GUARDCheck for corrosion,deformation, rust, and damage.HUB BEARING UNIT(MAGNETIC ENCODER)Check for faultymovement and wear.FRONT BRAKE DISCCheck for wear, damage, and rust.SPINDLE UNIT26 x 1.5 mm328 N·m(33.4 kgf·m, 242 lbf·ft)Replace.Apply a small amount of engine oilto the seating surface of the nut.KNUCKLECheck for deformation anddamage.DAMPER PINCH BOLT16 x 1.5 mm175 N·m(17.8 kgf·m, 129 lbf·ft)Replace.FLATHEAD SCREW6 x 1.0 mm9.3 N·m(0.95 kgf·m,6.9 lbf·ft)12 x 1.25 mm98 N·m(10.0 kgf·m, 72 lbf·ft)?

Special Tools Required

  • Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
  • Ball Joint Remover, 28 mm 07MAC-SL0A202
  • Ball Joint Thread Protector, 14 mm 071AF-SZNA100
  • Ball Joint Remover, 32 mm 07MAC-SL0A102

NOTE: Refer to the Exploded View as needed during the following procedure.

    Front Knuckle/Hub Bearing Unit Replacement

    Hub Bearing Unit Replacement

    See More:

    Honda Odyssey Service Manual > Headlight Leveling Motors: License Plate Light Replacement
    Remove the tailgate lower trim panel. Push the license plate light (A) to the side to release the retaining spring, and pull out the license plate light. A Disconnect the 2P connector (A) from the light. License Plate Light:5 W ABCD Separate the lens (B) and the housing (C), then remove the bulb (D) ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0122