Honda Odyssey Service Manual: Removal

  1. Raise and support the vehicle.

  1. Remove the front wheel.

  1. Remove the wire guide rubber (A) and the clip (B) from the damper (C). Do not disconnect the wheel speed sensor connector.

  2. 8 x 1.25 mmABCD
  3. Remove the brake hose bracket (D) from the damper.

  1. Remove the flange nut (A), while holding the joint pin (B) with a hex wrench (C), and disconnect the stabilizer link (D) from the damper.

  2. BCDA12 x 1.25 mm
  1. Remove the damper pinch bolts (A) and flange nuts (B) from the damper.

    NOTE: Do not allow the knuckle to rotate too far outward. This may allow the driveshaft inboard joint to come apart.

  2. BReplace.A16 x 1.5 mmReplace.
  1. Remove the cowl top wiper cover (A), then remove the flange nuts (B) from the top of the damper. Do not let the damper/spring drop down under its own weight.

  2. AB10 x 1.25 mmReplace.
  1. Remove the damper/spring (A).

    NOTE:

    • The left and right damper springs are different. Mark the springs L and R before you continue.

    • Be careful not to damage the body.

  2. A

    Front Damper/Spring Removal and Installation

    Installation

    See More:

    Honda Odyssey Owners Manual > Driving: Parking Your Vehicle
    Do not park your vehicle near flammable objects, such as dry grass, oil, or timber. Heat from the exhaust can cause a fire. When Stopped 1. Depress the brake pedal firmly with the shift lever in . 2. Firmly apply the parking brake. 3. Move the shift lever from to . 4. Turn off the engine. Always set ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2022 Copyright www.hodyssey.net
    0.0125