Honda Odyssey Service Manual: BSI OFF Switch Test/Removal/Installation

Honda Odyssey Service Manual / Chassis / Brake Control and Vehicle Dynamics / BSI OFF Switch Test/Removal/Installation

  1. Push out the BSI OFF switch (A) from the back of the dashboard, and disconnect the BSI OFF switch 6P connector (B).

    2. AB

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminal in each switch position according to the table.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals
    TerminalPosition45PRESSEDRELEASED

  • If the switch does not work as described in the table, replace the switch.

  • If the switch tests OK, go to step 3.

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminals No. 1 and No. 2.   There should be continuity at all times.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals?

  1. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

    2. BA

  1. Install the BSI OFF switch in the reverse order of removal.

    Brake Control and Vehicle Dynamics

    BSI OFF Switch Test/Removal/Installation

    See More:

    Honda Odyssey Owners Manual > Airbags: Airbag System Indicators
    If a problem occurs in the airbag system, the SRS indicator will come on and a message appears on the multi-information display*. SRS (Supplemental Restraint System) Indicator ■ When the ignition switch is turned to ON The indicator comes on for a few seconds, then goes off. This tells you the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0079