Honda Odyssey Service Manual: Suspension Stroke Sensor Replacement

Honda Odyssey Service Manual / Chassis / Brake Control and Vehicle Dynamics / Suspension Stroke Sensor Replacement

  1. Raise the vehicle, make sure it is securely supported.

  1. Disconnect the 3P connector (A) from the suspension stroke sensor (B).

    2. Front

    ABDo not disassemble.D9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Replace.C

    Rear

    A9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Do not disassemble.BCD

  2. Remove the bolt(s) (C) and the nut (D), then remove the suspension stroke sensor.

  3. Install the sensor in the reverse order of removal.

  4. After installing, do the headlight initial position learning.

    BSI OFF Switch Test/Removal/Installation

    Wheel Speed Sensor Replacement

    See More:

    Honda Odyssey Owners Manual > To Use Maintenance MinderTM: Resetting the Display
    Reset the engine oil life display if you have performed the maintenance service. 1. Turn the ignition switch to ON . 2. Display the engine oil life by repeatedly pressing the SEL/RESET button. 3. Press and hold the SEL/RESET button for 10 seconds or more. ► The oil life reset mode is displayed ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.012