Honda Odyssey Service Manual: Wheel Runout Inspection

Honda Odyssey Service Manual / Chassis / Wheels/Tires / Wheel Runout Inspection

  1. Raise and support the vehicle.

  1. Check for bent or deformed wheels.

  1. Set up the dial gauge as shown, and measure the axial runout by turning the wheel.

    Front and rear wheel axial runout:

    Standard:

    Steel wheel: 0-0.7 mm (0.0-0.028 in)

    Aluminum wheel: 0-0.3 mm (0-0.012 in)

    Service limit: 2.0 mm (0.079 in)

  1. Reset the dial gauge to the position shown, and measure the radial runout.

    Front and rear wheel radial runout:

    Standard:

    Steel wheel: 0-0.5 mm (0.0-0.020 in)

    Aluminum wheel: 0-0.3 mm (0-0.012 in)

    Service limit: 1.5 mm (0.059 in)

  2. If the wheel runout is not within the specification, check the wheel bearing end play, and make sure the mating surfaces on the brake disc or the brake disc/drum and the inside of the wheel are clean.

  3. If the bearing end play is within the specification but the wheel runout is more than the service limit, replace the wheel.

    Wheel Bolt Replacement

    Electrical

    See More:

    Honda Odyssey Owners Manual > Quick Reference Guide: Instrument Panel
    Gauges /Information Display* (/ Multi-Information Display*/System Indicators System Indicators Lights Reminders System Indicators ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0074