Honda Odyssey Service Manual: Alternator Reassembly

  1. If you removed the OAD pulley, install it.

  1. Remove any grease or any oil from the slip rings.

  1. Put the rear housing assembly and the drive-end housing/rotor assembly together, tighten the four through bolts.

  1. Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.6 mm (1/16 in) diameter) to hold them there.

  2. AB
  1. Install the brush holder assembly, and pull out the pin or drill bit.

  2. Install the end cover.

  3. After assembling the alternator, turn the pulley by hand to make sure the rotor turns smoothly and without noise.

  4. Install the alternator.

    Rotor Slip Ring Test

    Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation

    See More:

    Honda Odyssey Service Manual > Body Exterior: Rear Bumper Reflector Replacement
    NOTE: Put on gloves to protect your hands. Take care not to scratch the rear bumper. Remove the rear bumper. Release the hooks (A), then remove the rear bumper reflector (B). AB Install the reflector in the reverse order of removal, and push the hooks into place securely. ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0156