Honda Odyssey Service Manual: Removal

  1. Remove the alternator.

  1. Clamp the alternator firmly in a vise.

  1. Remove the over-run alternator decoupler (OAD) pulley seal cap (A) by piercing the center of the rubber cap with a flat screwdriver and prying it loose.

    NOTE: While the cap is off, the grease inside the OAD pulley is exposed. Do not wipe the grease off, and make sure it does not become contaminated.

  2. A
  1. Insert the alternator OAD pulley holder (A) into the OAD pulley.

  2. A07AAB-TK8A100
  1. Place a 10 mm deep socket wrench (A) through center of the alternator OAD pulley holder (B), onto hex on the end of the alternator shaft.

  2. ABCD
  3. Hold the alternator OAD pulley holder with a 17 mm   wrench (C), then turn the alternator shaft clockwise.

  4. Remove the OAD pulley (D).


    Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation

    Installation

    See More:

    Honda Odyssey Owners Manual > Handling the Unexpected: Shift Lever Does Not Move
    Follow the procedure below if you cannot move the shift lever out of the (P position. ■Releasing the Lock 1. Set the parking brake. 2. Remove the key from the ignition switch. 3. Wrap a cloth around the tip of a small flattip screwdriver. Put it into the shift lock release slot as shown in the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0075